Finding The Preset; Example Workpiece - Finding The Preset - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

10
10.4.3

Finding the preset

To machine the bearing seat, you will need to find the preset. According to the
drawing, the dimensions are referenced to the mating surface of the bearing. In
the drawing, the mating surface of the bearing is highlighted in green. Based on
this preset the product then calculates all values for the relative coordinate system.
Figure 49: Example workpiece – finding the preset
206
On the lathe, insert the finishing tool into the tool holder
Tap Tools on the status bar
The Tools dialog appears
Tap Finishing tool
Tap Confirm
The Finishing tool is shown in the status bar
Tap Auxiliary functions in the status bar
Tap Presets in the dialog
The Set preset data dialog box opens
On the workpiece blank, move the finishing tool along Z
in the negative direction for approx. 17 mm
Tap Save position
The current position of the tool is saved
Retract the tool to a safe position
In the Z input field, enter the value
Tap Confirm in the wizard
The Select preset dialog appears
in the Selected preset input field
Select preset 0
Tap Confirm in the wizard
The probed coordinate is loaded as preset
Turning – Quick Start | Setting up the lathe
0
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018