Programming Support; Creating A Program Header - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

18
18.3.1

Programming support

The product provides the following features to assist you in creating programs:
When you add a block, the wizard displays information on the parameters that
are required for the selected block type.
If a block contains errors or undefined parameters, it is displayed in red type in
the list.
If problems occur, the wizard displays the message The program contains
incomplete program blocks. You can tap the arrow keys to go to the program
blocks concerned.
The optional simulation window shows a visualization of the current block.
Further information:
18.3.2

Creating a program header

286
"Using the simulation window", Page 236
All changes to a program can be automatically saved.
Tap Save program automatically in the program management
All changes will be automatically saved immediately
Tap Create new program in the program management
In the dialog select the storage location, e.g.
Internal/Programs, in which you want to save the program
Enter a name for the program
Confirm the entry with RET
Tap Create
A new program containing the Program header start block is
created
The name of the program is displayed on the toolbar
Enter a unique name in the Name field
Confirm the entry with RET
Change the unit of measure with the slide switch, if required
Turning – Programming | Creating a program
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018