Connecting A Printer - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

Installation | Connecting a printer
5.7

Connecting a printer

Connecting a USB printer
Comply with the pin layout
Remove and save the dust protection caps
Route the cables based on the mounting variant
Further information:
Connect USB printer to USB Type-A port (X31, X32, X33, X34). Make sure the
USB cable connector is fully inserted
Further information:
Pin layout X31, X32, X33, X34
3 2 1
4
1
DC 5 V
Connecting an Ethernet printer
Note the following pin layout
Remove and save the dust protection caps
Route the cables based on the mounting variant
Further information:
Connect the Ethernet printer to the Ethernet port X116 using a standard CAT.5
cable. The cable connector must firmly engage in the port
Further information:
Pin layout of X116
1 2 3 4 5 6 7 8
1
D1+ D1–
(TX+) (TX–)
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018
"Assembly of the product", Page 42
"Product overview", Page 50
2
Data (–)
"Assembly of the product", Page 42
"Product overview", Page 50
2 3 4
D2+ D3+
(RX+)
3
Data (+)
5 6 7
D3– D2– D4+
(RX–)
4
GND
8
D4–
5
59