Configuring The Axes - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

7
7.3.3

Configuring the axes

Before you start measuring, you need to reference the axes. In addition, you have
to configure the parameters of the connected encoder for every axis.
The procedure varies depending on the interface type of the connected encoder
and on the type of axis:
Encoders with an interface of the EnDat type:
The axes are automatically homed
Many parameters are automatically adopted
You have to configure individual parameters manually
Further information:
Page 113
Encoders with an interface of the 1 V
You have to perform a reference mark search
You have to configure all parameters manually
Further information:
Page 116
Spindle or Gear spindle type of axis:
You have to configure the inputs and outputs, as well as further parameters
Further information:
For the parameters of HEIDENHAIN encoders that are typically connected to the
product, refer to the overview of typical encoders.
Further information:
Then you can perform the error compensation.
Further information:
112
"Configuring the axes for encoders with EnDat interface",
and 11 µA
PP
"Activating the reference mark search", Page 115 and
"Spindle axis S", Page 341
"Overview of typical encoders", Page 118
"Performing error compensation", Page 121
Commissioning | Steps for commissioning
type:
PP
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018