HEIDENHAIN POSITIP 8000 Operating Instructions Manual page 232

13
Bolt hole circle block
Figure 56: Schematic display of the bolt hole circle block
Parameter
Number of holes
X coordinate of
center
Y coordinate of
center
Radius
Starting angle
Stepping angle
Depth
Clearance height
Feed rate
Feed rate for
plunging
232
Description
Number of holes
Center of the bolt hole arc in the X plane
Center of the bolt hole arc in the Y plane
Radius of the bolt hole arc
Angle of the 1st hole of the bolt hole arc
Angle of the circle segment
Default: bolt hole circle
Target depth for drilling in the Z plane
Default: Drilling through-holes (not available for NC-
controlled Z axis)
Starting depth for milling in the tool axis (only for NC-
controlled Z axis)
Traversing speed of the tool axis (only for NC-controlled
Z axis)
Traversing speed of the tool axis for plunging (only for
NC-controlled Z axis)
Milling – MDI mode | Block types
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018