Performing The Reference Mark Search After Startup; User Interface - HEIDENHAIN POSITIP 8000 Operating Instructions Manual

6
6.7

Performing the reference mark search after startup

If the reference mark search is active on the unit, then a wizard will ask you to
traverse the reference marks of the axes.
After logging in, follow the instructions of the wizard
The Reference symbol stops blinking upon successful completion of the
reference mark search
Further information:
Further information:
6.8

User interface

72
Basic operation | Performing the reference mark search after startup
If the unit is configured with the Turning application mode and a
spindle axis S, then you must define an upper limit for the spindle
speed prior to a possible machining operation.
Further information: "Defining the upper limit for the spindle speed (in
the Turning application mode)", Page 223
If the reference mark search after unit start is active, then all of the
unit's functions will be disabled until the reference mark search has
been successfully completed.
Further information: "Reference marks (Encoder)", Page 336
The reference mark search does not need to be performed for serial
encoders with EnDat interface, because the axes are automatically
homed.
"Operating elements of the position display", Page 88
"Activating the reference mark search", Page 115
The unit is available in different versions, which are variously equipped.
The user interface and available functions may vary depending on the
version.
HEIDENHAIN | POSITIP 8000 | Operating Instructions | 09/2018