16.6.10 Encoder - HEIDENHAIN ND 7000 Operating Instructions Manual

16

16.6.10 Encoder

Path:
Encoder configuration for axis
Parameters
Encoder input
Incremental signal
Encoder model
Signal period
Line count
Mechanical ratio
Reference marks
Analog filter frequency
250
Settings ► Axes ► X or Y or Z or Zo or C ► Encoder
Explanation
Assignment of the encoder input to the axis of the product
Settings:
Not connected
X1 (1 Vpp)
X2 (1 Vpp)
X3 (1 Vpp)
Signal of the connected encoder
Settings:
1 Vpp: Sinusoidal voltage signal
11 µApp: Sinusoidal current signal
Default value: 1 Vpp
Connected encoder model
Settings:
Linear encoder: Linear axis
Angle encoder: Rotary axis
Angle encoder as linear encoder: Rotary axis is displayed as
linear axis
Default value: Depending on the connected encoder
For linear encoders:
length of a signal period
Setting range: 0.001 µm ... 1000000.000 µm
Default value: 20.000
For angle encoders and display of a rotational axis as a linear
axis:
number of lines
Setting range: 1 ... 1000000
Default value: 1000
For display of a rotational axis as a linear axis:
traverse path in mm per revolution
Setting range: 0.1 mm ... 1000 mm
Default value: 1.0
Configuration of the Reference marks
Further information: "Reference marks (Encoder)", Page 252
Frequency value of the analog low-pass filter (not with TTL)
Settings:
33 kHz: Suppression of interference frequencies above
33 kHz
400 kHz: Suppression of interference frequencies above
400 kHz
Default value: 400 kHz
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Settings | Axes