Configuring The Axes - HEIDENHAIN ND 7000 Operating Instructions Manual

Commissioning | Steps for commissioning
Setting the units of measure
You can set various parameters to define the units of measure, rounding methods
and decimal places.
Further information:
7.3.3

Configuring the axes

Activating the reference mark search
The product uses the reference marks to reference the machine table to the
machine. If the reference mark search has been activated, a wizard appears on
startup of the product and asks the user to move the axes for the reference mark
search.
Requirement:
configured in the axis parameters.
The automatic reference mark search on startup of the product can be
canceled depending on the configuration.
Further information:
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Tap Settings in the main menu
Tap General
Tap Units
To set a unit of measure, tap the corresponding drop-down
list and select the unit
To set the rounding method, tap the corresponding drop-
down list and select the rounding method
To set the number of decimal places displayed, tap – or +
"Units", Page 234
The installed encoders have reference marks that have been
"Reference marks (Encoder)", Page 252
Tap Settings in the main menu
Tap Axes
Open in the sequence
General settings
Reference marks
Use the ON/OFF sliding switch to activate Reference mark
search after unit start
The reference marks must be traversed every time the
product is started
The functions of the product will only be available after the
reference mark search has been completed
The Reference symbol stops blinking upon successful
completion of the reference mark search
Further information:
display", Page 78
"Operating elements of the position
7
95