Selecting A Tool - HEIDENHAIN ND 7000 Operating Instructions Manual

11
11.5

Selecting a tool

The currently selected tool is displayed on the status bar. Here you can also access
the tool table where you can select the tool you want to use. The associated tool
parameters are applied automatically.
The product provides a tool radius compensation feature that enables you to
directly enter the workpiece dimensions as specified in the drawing. During
machining, the product will then automatically display a traverse path that is
increased (R+) or decreased (R–) by the tool radius.
188
The setup engineer (Setup) may have already made the settings in the
tool table.
Further information: "Creating a tool table", Page 138
Tap Tools on the status bar
The Tools dialog appears
Tap the tool you want to use
Tap Confirm
The associated tool parameters are applied automatically
The selected tool is shown on the status bar
Mount the desired tool on the machine tool
Milling – Manual operation | Selecting a tool
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018