Accessing The Cli To Set System Passwords - Motorola BSR 64000 Quick Start Manual

BSR 64000 Quick Start Guide
•
BSR 64000 Installation Guide

Accessing the CLI to Set System Passwords

Follow these steps to access the CLI from a console session in order to configure
password privileges for enabled modes and telnet:
Note: Make sure that the serial cable is connected properly and the terminal
application is configured correctly. Refer to the BSR 64000 Installation Guide
for more information.
1. Configure the terminal application on your PC to use COM port 1 or 2.
2. Configure the terminal port to the following settings:
•
•
•
•
•
3. Start your terminal or terminal application to connect to the BSR.
4. Power on the BSR 64000.
Warning: Do not interrupt the boot process.
5. The terminal session begins and the password prompt displays. The password is a
null value by default. Press the Enter key. The RDN> prompt displays.
6. To enter Privileged EXEC mode, use the enable command in User EXEC mode,
as shown in the following example:
4
Bits per second: 9600 bits per second
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None