Routing The Cable; Fitting A Lightning Protection Unit; Warning Not To Over Tighten Cable Gland; Disconnecting The Odu - Motorola PTP 300 Series User Manual

Motowi4 series

Hide thumbs Also See for PTP 300 Series:

Table of Contents

Should it be necessary to disconnect the PIDU Plus to ODU cable at the ODU, this can be

achieved by removing the weather prooﬁng gland and depressing the RJ45 locking tab with a

small screwdriver as shown below:

CAUTION: Ensure that power is removed from the system at the PIDU Plus to prevent damage

to the ODU while making or breaking the connection.

7.7.4 Routing the Cable

After connecting the cable to the ODU it can be routed and secured using standard cable routing

and securing techniques. When the cable is in place it can then be cut to the desired length at the

PIDU Plus prior to connection to the LPU.

If you have opted to ﬁt a Lightning Protection unit, this should be installed by following the

instructions

Section 11

Installation

Figure 20 Warning Not To Over

tighten Cable Gland

Figure 21 Disconnecting the ODU

"Lightning Protection".

Table of Contents