RFSwitch# co
1.4.3 Deleting Entries
Use any of the following keys (or key combinations) to delete command entries:
Keystrokes
Backspace
Ctrl-D
Ctrl-K
Ctrl-W
Esc, D
1.4.4 Re-displaying the Current Command Line
If entering a command and the system suddenly sends a message, you can recall the
current command entry. To re-display the current command line (refresh the screen), use
the following key combination:
Keystrokes
Ctrl-L
1.4.5 Command Output pagination
Output often extends beyond the visible screen length. For cases where output continues
beyond the screen, the output is paused and a
prompt displays at the bottom of the screen. To resume the output, press the Return
Quit)
key to scroll down one line or press the Spacebar to display the next full screen of output.
NOTE: The characters entered before the question mark are reprinted
to the screen to complete the command entry.
Purpose
Deletes the character to the left of the cursor
Deletes the character at the cursor
Deletes all characters from the cursor to the end of the command line
Deletes a word up to the cursor
Deletes from the cursor to the end of the word
Purpose
Re-displays the current command line
Press Any Key to Continue (Q to
Introduction 1-
11