When Replacing Pressure Belt Unit-Related Durable Parts - Canon imagePRESS C1 P Service Manual

and spread it out evenly using the paper slip [2].
[1]
[2]
1-3) Apply 0.1ml of silicone oil at the center (30mm inside from the both
ends) on the surface of the inlet roller and spread it out evenly using a
paper slip. Be sure to apply the oil to cover approx.
1/4-turn of the roller.
[1]
[2]
1-4) Turn the inlet roller so that the oil-coated surface is hiding inside the
unit. This is to prevent the coated oil to be scraped by the belt when
attaching the pressure belt.
[1]
2) Clean the fixing roller and the pressure belt (use alcohol solution + lint-
free paper)
3) Check the nip width (COPIER > FUNCTION > FIXING > FX1-NIP1)
13.4.7 When Replacing Pressure Belt Unit-Related
Durable Parts
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1 (CUSTOM) / im-
agePRESS C1+ (Printer) / imagePRESS C1+
Here shows the service task when replacing the following parts at the same
time.
- Pressure belt
- Pressure pad
- Pad cover
- Oil coating roller
1) Apply silicone oil at the areas described below:
-Center on the surface of pressure pad: 0.4ml
-Surface of oil coating roller: 0.2ml
-Surface of inlet roller: 0.1ml
-Pad cover surface between separation roller and pad cover: 0.1ml
[Tools to be used]
30mm
30mm
F-13-22
30mm
30mm
F-13-23
F-13-24
-Silicone oil (Parts Number: FY9-6011)
-Dropper
1-1) Make a paper slip to be used for applying the oil. Cut A4 paper into 1/
8 (approx.) and fold the piece into three.
1-2) Apply 0.4ml of silicone oil at the center [1] (30mm inside from the both
ends) on the surface of pad cover and spread it out evenly using the pa-
per slip [2].
1-3) Apply 0.1ml of silicone oil at the center (30mm inside from the both
ends) on the surface of pad cover (that is facing the separation roller)
and spread it out evenly using the paper slip [2].
1-4) While turning the oil coating roller, apply 0.2ml of silicone oil at the
center [1] (30mm inside from the both ends) on the surface of the roller
and spread it out evenly using the paper slip [2].
0020-8937
1-5) Apply 0.1ml of silicone oil at the center (30mm inside from the both
ends) on the surface of the inlet roller and spread it out evenly using
the paper slip. Be sure so apply the oil to cover approx. 1/4-turn of the
roller.
[1]
30mm
[2]
30mm
F-13-25
30mm
[1]
[2]
30mm
F-13-26
[1]
30mm
[2]
30mm
F-13-27
Chapter 13
13-9