Removing The Pre-Transfer Corona Assembly Pad Folder - Canon imagePRESS C1 P Service Manual

PRESS C1+
1) Open the front cover.
2) Detach the processing unit cover.
3) Remove the pre-transfer corona assembly. (page 7-88)Reference [Re-
moving the pre-transfer corona assembly]
7.14.9.2 Removing the Pre-transfer corona assembly pad
folder
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Pinch the hook [1] of the pre-transfer corona assembly pad holder to re-
move the pre-transfer corona assembly pad holder [2] in the direction
shown by the arrow.
[2]
Points to Note when Attaching the Pre-transfer Corona Assembly
Pad Holder
When attaching the pre-transfer corona assembly slider [1] and the pre-trans-
fer corona assembly pad holder [2], fit them in the direction shown by the
figure below.
7.14.10 Pre-Transfer Corona Slider
7.14.10.1 Preparation for Removing the Pre-transfer
Corona Assembly Slider
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front cover.
2) Detach the processing unit cover.
3) Remove the pre-transfer corona assembly. (page 7-88)Reference [Re-
moving the pre-transfer corona assembly]
4) Remove the pre-transfer corona assembly pad holder. (page 7-89)Ref-
erence [Removing the Pre-transfer corona assembly pad folder]
7.14.10.2 Removing the Pre-transfer Corona Assembly
Slider
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Slide the pre-transfer corona assembly slider hook [1] in the direction
shown by the arrow [A] (Be careful not to get the corona wire stuck on)
and then turn the pre-transfer corona assembly slider [2] in the direction
shown by the arrow [B].
[1]
F-7-137
[2]
[1]
F-7-138
0013-9734
Points to Note when Attaching the Pre-transfer Corona Assembly
Slider
When attaching the pre-transfer corona assembly slider [1] and the pre-trans-
fer corona assembly pad holder [2], fit them in the direction shown by the
figure below.
7.14.11 Drum Unit
7.14.11.1 Preparation for Removing the Drum Unit
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front cover.
2) Detach the processing unit cover.
3) Lift the hopper unit.
4) Remove the primary corona assembly. (page 7-86)Reference [Remov-
ing the Primary Corona Assembly]
5) Remove the pre-transfer corona assembly. (page 7-88)Reference [Re-
moving the pre-transfer corona assembly]
7.14.11.2 Removing the Drum Unit
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Turn the primary transfer pressure lever [1] down.
- 1 screw [2]
0013-9735
0013-9736
2) Remove the drum fixing parts [1].
- 1 screw [2]
[2]
[B]
[A]
[1]
F-7-139
F-7-140
[1] [2]
F-7-141
Chapter 7
[2]
[1]
0014-0069
0014-0070
7-89