Canon imagePRESS C1 P Service Manual page 220

Chapter 2
28) Insert the cable [1] into the voice board terminal [2].
29) Fix the redundant cable [1] in place by the 2 wire saddles [2].
Be sure not to let the cable slacken.
30) Insert the 2 power supply plugs of the main body (1 on the backside of the machine, 1 on the left side of the machine) into 2 independent outlets from different
power sources, and then turn on the main power.
31) Check that the voice board is recognized.
Service mode > COPIER > DISPLAY > ACC-STS > PCI1
When indicated as 'Voice Board' on the screen, the voice board is successfully recognized.
2. Setup After Installation
To use the voice guidance kit-A2 after power-on, it is necessary to set the followings.
1) Additional Functions > System Settings > Voice Guide Management Settings > Use Voice Guide
2) Select [ON]
3) Press [ON]
Default: [OFF]
3. Checking Operations
- At the Point of Use
1) Hold down [Reset] for 3 sec. or more.
2) If the copy number indication on the screen is surrounded by a red-colored frame, 'Voice Guidance' is available.
- At the Stop of Use
1) Hold down [Reset] for 3 sec. or more.
2-126
[1]
[2]
F-2-457
[2] [1]
F-2-458
[2] [1]
F-2-459