Canon imagePRESS C1 P Service Manual page 1051

Chapter 16
Subheading
P-PRINT
P-PRINT
KEY-HIST
HIST-PRT
TRS-DATA
USER-PRT
LBL-PRNT
PRE-EXP
D-PRINT
1ATVC-EX
ENV-PRT
I-BD-OFF
PJH-P-1
16-154
COPIER > FUNCTION > MISC-P
Print out the service mode setting value.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
It takes approximately 15 seconds before printing starts.
Print out the service mode standard value
Execute the print out of the service mode standard value.
Left/right margin adjustment value (COPIER > ADJUST > FEED-ADJ > BLK-SML2) for the
second side on small size is added as an output item.
When executing P-PRINT with a printer model, an item for second-side left/right margin
adjustment value on small size was missing. Thus, this item is added in this change.
This item applies to the upgraded device or later (DCON Ver11.03 or later, Cont Ver24.04 or
later).
Print out the control panel key input history.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
Print out the jam history and error history.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
Transfer the data received in memory to the box.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
Print out the user mode list.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
It takes approximately three seconds before printing is performed.
Print out the service label.
Operation method
1) Set the A4/LTR paper in Cassette 1.
2) Select this item.
3) Press the OK key to perform printing.
It takes approximately 15 seconds before printing is performed.
Check the lighting operation of the post-exposure lamp (LED).
Operation method
1) Press an item to highlight it.
2) Press the OK key. Each operation is performed for a few seconds and stops automatically.
3) Press the OK key to perform printing.
Reference
When a failure occurs to the photosensitive drum caused by the lighting operation of the post-
exposure lamp, rotate the drum.
Print out the service mode (DISPLAY).
This is a mode to print out only the items displayed in the DISPLAY service mode (excluding
items output by P-PRINT/LBL-PRINT/HIST-PRINT and ALARM).
Operation method
1) When selecting the item to highlight and pressing OK key, the operation is started.
Forcibly execute the primary ATVC.
Execute this mode when replacing the ITB or ITB unit.
Operation method
1) Select this item.
2) Press the OK key to start operation. The operation completes after approximately one minute.
Print out the log of changes in temperature/humidity in the machine and fixing temperature.
Print out the changes in temperature/humidity in the machine and fixing temperature (center) as
log data based on the monitor output from the environmental sensor and noncontact thermistor.
Separate the ITB cleaning brush roller.
Separate the ITB cleaning brush roller from ITB.
Print out the print job history with detailed information. (for 100 jobs)
Print out the history of 100 jobs stored in the copier main unit with detailed information.
[Operation]
Press the item to highlight it, and press the OK key to perform printing.
[Remarks]
The print job history is printed out with detailed information which is not displayed/output in the
job history screen displayed by "system condition > print > job history > printer" and in the print
job history report.
The history of the latest 100 jobs are printed out. When the number of recorded print jobs is less
than 100, all the recorded jobs are printed out.
The difference to PJH-P2 is the number of jobs printed out.
T-16-157
Contents Level
1
1
1
1
1
1
1
1
1
1
1
1
1