Canon imagePRESS C1 P Service Manual page 1000

Subheading
ADJ-X-MG
2. CCD
Subheading
W-PLT-X/Y/Z
EC-B/G/R
CCDU-RG
CCDU-GB
FCCDU-RG
FCCDU-GB
COPIER > ADJUST > ADJ-XY
Make a fine adjustment of sub scanning magnification for reader copyboard reading.
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
Adjustment range
-50 to +50
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
When you changed the setting value for this item, write down the changed value in the service
label.
COPIER > ADJUST > CCD
Enter the white level data for the white plate.
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
- When you replaced the copyboard glass, enter the numeric value indicated on the copyboard
glass.
Adjustment range: 1 to 9999
[Factory setting value: Factory adjustment value / Value after RAM clear: W-PLT-X=8271 : W-
PLT-Y=8735 : W-PLT-Z=9418]
When you changed the setting value for this item, write down the changed value in the service
label.
Display the correction value (Blue/Green/Red) after EC coat correction was performed, and enter
a value.
Adjustment range: 10000 to 15000
Standard value: 10000
Correction value of color registration between Red and Green in the sub scanning direction, which
is dependent on the CCD unit
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
Adjustment range: -9 to 9
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
When you changed the setting value for this item, write down the changed value in the service
label.
Correction value of color registration between Green and Blue in the sub scanning direction,
which is dependent on the CCD unit
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
Adjustment range: -9 to 9
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
Correction value of color registration between Red and Gree in the sub scanning direction, which
is dependent on the CCD unit at factory setting
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
Adjustment range: -9 to 9
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
When you changed the setting value for this item, write down the changed value in the service
label.
Correction value of color registration between Gree and Blue in the sub scanning direction, which
is dependent on the CCD unit at factory setting
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
Adjustment range: -9 to 9
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
When you changed the setting value for this item, write down the changed value in the service
label.
Contents
T-16-104
Contents
Chapter 16
Level
1
Level
1
1
1
1
1
1
16-103