Canon imagePRESS C1 P Service Manual page 1013

Chapter 16
Subheading
DOCST-M
LA-SPEED
STRD-S
STRD-L
RVM-SPD
16-116
Adjust the document stop position when a feeder is used. (for manual feeding)
Setting range
-7 to +7 (Unit: 0.5mm)
Remarks
The procedure to adjust positions is shown below.
When each item is executed, the machine feeds the paper set on the feeder document tray and
stops it on the copyboard glass. Visually check this status, and make an adjustment so that the
document stops at a correct position.
1) Press each item to highlight it.
2) Place a sheet of A3-size paper on the document tray.
3) Enter numeric values using numeric keys.
- When you increase the value, the paper moves toward the trail edge.
- When you decrease the value, the paper moves toward the lead edge.
4) Press the OK key. The paper placed on the document tray is fed and stops on the copyboard
glass.
5) Open the feeder slowly, and check the position where the paper stopped. After checking it,
close the feeder slowly without removing the paper.
6) Press the OK key. The paper on the copyboard glass is delivered to the document tray of the
feeder.
Adjust the document feeding speed for feeder stream reading.
When you increase the setting value, the speed becomes slow. (The image is shortened.)
Adjustment range: -30 to 30 (Unit: 0.1%)
Adjust the optical system stop position at stream reading mode for small size document.
Setting range
-7 to +7 (Unit: 0.5mm)
Remark:
The position of printed image is changed.
By setting the value larger, the image shifts toward the front.
By setting the value smaller, the image shifts toward the rear.
Adjust the optical system stop position at stream reading mode for large size document.
Setting range
-7 to +7 (Unit: 0.5mm)
Remark:
The position of printed image is changed.
By setting the value larger, the image shifts toward the front.
By setting the value smaller, the image shifts toward the rear.
Make a fine adjustment of the feeding speed of the reverse motor which drives the registration
roller.
When you perform synchronous feeding with the belt and registration at stream reading DF, it is
necessary to set a constant speed for the belt and registration.
Usage
Make this adjustment when there is a difference in speed between the belt and registration caused
by roller friction, etc., and a jam occurs.
Setting range: -30 to 30 (Unit: 0.1%)
FEEDER>ADJSUT
Contents Level
1
1
1
1
2