4. Fold a sheet of paper (50mm x 20mm/ 64g to 80g plain paper from SK) into two > insert it between [3] and [4] as shown [5] in the photo > lift the separation
drive mount assembly [6] in the direction of the arrow [7] > tighten the 2 binding screws (M4) that was loosened in Step 3 to fix the separation drive mount
assembly in place.
5. Remove the paper inserted in Step 4, and open it; then inset it between the flange of the one-way gear and the push-on area of the rear fixing gear to check
to make sure that it can make its way without any resistance.
14.3.7.4 E014-0003 : Due to ball bearing breakage in fixing belt drive assembly
Ball bearing [1] equipped to the fixing belt drive shaft was broken, resulting heavy load on the belt drive motor and E014-0003 occurrence.
- E014-0003: Detects unlock of motor lock for 1 sec or more after the belt drive motor performs stabilized rotation.
Cause
Fixing belt drive shaft and ball bearing core were dislocated, so the ball bearing was broken. In order to solve this problem, the sheet metal shape of the fixing
belt drive assembly and ball bearing [1] (XG9-0407 to XG9-0628) were changed from the machine serial number shown below. In addition, due to this change,