Feeder - Canon imagePRESS C1 P Service Manual

Chapter 16
Subheading
HD-CHECK
HD-CLEAR
DEBUG-1
DEBUG-2

16.5.2 FEEDER

16.5.2.1 FEEDER List
imagePRESS C1 / imagePRESS C1+
Subheading
SENS-INT
BLT-CLN
REG-CLN
16.6 OPTION (Machine Settings Mode)
16.6.1 COPIER
16.6.1.1 COPIER List (BODY)
imagePRESS C1
16-156
COPIER > FUNCTION > SYSTEM
Execute the partition check and recovery specified by CHK-TYPE.
Operation method
1) Select this item.
2) Press the OK key.
3) The result (1: OK, 2: NG (hardware), 3: NG (software), recovered sector / substitute sector) is
displayed.
Initialize the partition specified by CHK-TYPE.
- When 0 or 4 is specified, this mode is invalid.
- When 1 is specified, the image control data saved in the SRAM area or versatile file saving area
is also initialized.
Operation method
1) Select this item.
2) Press the OK key.
When 1 or 3 is selected in CHK-TYPE and <HD-CLEAR> is executed, initialization is performed
after the power is turned OFF/ON.
It takes approximately five minutes for initialization. During the initialization, the progress bar
advances slowly. Do not turn off the power during initialization.
Use it to set the type of log to store/timing of storage to the HDD.
settings: 0 to 3 (default: 0)
- Do not use for servicing (For the analysis of the cause of trouble)
- Obey the instruction by the quality support section for usage.
Use it to print out logs stored on the HDD.
<Procedure>
1) Select the item.
2) Press the OK key.
3) See that the log is printed. (about 2 sheets of A4)
- Do not use for servicing (For the analysis of the cause of trouble)
- Obey the instruction by the quality support section for usage.
Select a sensitivity adjustment item of each feeder sensor, and press the OK key. Initialization of
the feeder sensor starts and the display in the screen changes to ACT. Initialization is completed
automatically, and the display changes to OK.
Provide an instruction to clean the feeder separation belt.
Press the item to highlight it, and press the OK key to execute each operation. After adjustment is
completed, the operation stops automatically.
Clean the registration roller by rotating the roller only and inserting white paper in the nip area.
When the registration roller has too much dirt, the "feeder cleaning" in the user mode is not
enough to clean it. It is more effective to insert paper through the nip area to clean it in the same
manner as separation cleaning.
Reference
The rotation of the roller stops when closing the pickup unit cover or opening the reverse delivery
unit cover or ADF main unit during operation.
Contents
T-16-159
FEEDER>FUNCTION
Contents
Level
1
1
2
2
0011-9645
Level
1
1
1
0014-3799