Canon imagePRESS C1 P Service Manual page 145

4) Put back the fixing/feeding unit [1].
Keep in mind not to mix up the harness.
5) Tighten the 5 screws [1].
6) Fit the drum fixing member [1].
- 1 screw [2]
[1]
F-2-134
[1]
F-2-135
[1]
F-2-136
[2]
7) Tighten the 2 process joint shafts [1] and the ITB joint shaft [2].
- Hold the drum fixing member [3] steady when tightening the shaft of the
ITB joint shaft [2].
- If the drum fixing member is not held steady, the shaft [2] will rotate
without tightening.
[1]
[2]
8) Connect the connector [1] and other 7 connectors [2].
[1]
9) Connect the 6 connectors [1], and fix it in place with the cable guide [2]
and the wire saddle [3].
[1]
Chapter 2
[1]
F-2-137
[3]
F-2-138
[2]
F-2-139
[1]
[2] [3]
F-2-140
2-51