Canon imagePRESS C1 P Service Manual page 1005

Chapter 16
Subheading
BLANK-C3
BLANK-C4
BLANK-PD
7. V-CONT
Subheading
EPOTOEST
VRT-F-OF
VCONT-Y/M/C/K
VBACK-Y/M/C/K
VCONT-L
VBACK-L
8. PASCAL
16-108
COPIER > ADJUST > BLANK
Set a lead edge margin for Cassette 3.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
Set a lead edge margin for Cassette 4.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
Set a lead edge margin for the side paper deck
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
COPIER > ADJUST > V-CONT
Electric potential offset value
Adjustment range: -100 to 100 (Unit: 1V)
[Factory setting value / Value after RAM clear: 0]
Adjustment of the L toner deposit
Adjustment range: -2, -1, 0, 1, 2
Adjust the target contrast electric potential (Y/M/C/K color).
Adjustment method
- The larger the setting value is, the darker the density is.
Adjustment range: -30 to 30 (Unit: 1V)
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
Adjust the electric potential (Y/M/C/K color) to eliminate fogging.
Adjustment method
- The larger the setting value is, the more fogging can be eliminated.
Adjustment range: -30 to 30 (Unit: 1V)
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
Adjust the target contrast electric potential (L color).
Adjustment method
- The larger the setting value is, the darker the density is.
Adjustment range: -30 to 30 (Unit: 1V)
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
Adjust the electric potential (L color) to eliminate fogging.
Adjustment method
- The larger the setting value is, the more fogging can be eliminated.
Adjustment range: -30 to 30 (Unit: 1V)
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
Contents
T-16-109
Contents
Level
1
1
1
Level
1
1
2
2
2
2