Pulling The Hopper Unit Up - Canon imagePRESS C1 P Service Manual

Points to Note When Lifting Up the Hopper Unit
- In case the copyboard cover is attached, make sure to open it prior to lifting
up the hopper unit to prevent any damages caused by contact.
- Check if the lock arm [1] at the left-lower to the hopper is hooked by the
shaft [2] and the hopper unit is locked.
[2]
[1]

10.5.2.3 Pulling the Hopper Unit Up

imagePRESS C1+ (Printer) / imagePRESS C1+
1) Pull the hopper unit shutter lever [1] forward to the end.
[1]
F-10-40
F-10-41
2) Open the toner replacement cover [1].
3) Remove the hopper left cover [1].
- 1 screw [2]
4) Remove the hopper right cover [1].
- 1 screw [2]
0020-5437
5) Remove two harnesses [2] from the clamp [1].
[1]
F-10-42
F-10-43
[1]
[2]
F-10-44
[1]
[2]
F-10-45
Chapter 10
[1]
10-17