Canon imagePRESS C1 P Service Manual page 1029

Chapter 16
Subheading
STIR-Y/M/C/K
STIR-4
SPLY-H-Y/M/C/K
SPLY-H-4
CARD
KEY
INISET-Y/M/C
AINR-OFF
E-RDS
16-132
COPIER>FUNCTION>INSTALL
Stir developer in the developing unit (Y/M/C/K).
Select an item to highlight it and press the OK key. The operation starts.
Stir four-color developer in order.
Operation method
Select an item to highlight it and press the OK key. The operation starts.
Perform initial supply from the toner container (Y/M/C/K) to the toner buffer.
Select an item to highlight it and press the OK key. The operation starts.
Perform initial supply from the four-color toner cartridge to the toner buffer.
Operation method
Select an item to highlight it and press the OK key. The operation starts.
Make a setting for installation of the card reader.
1 to 2001 [Factory setting value / Value after RAM clear: 0]
Enter the card number and press the OK key. (Numbers for the number of cards specified by
COPIER>OPTION>BODY>CARD-RNG in Level 2 starting from the entered number are
available.)
The card control information (a section ID and password) is initialized.
Recognize the control key function.
0: Do not recognize the control key function.
[Factory setting value / Value after RAM clear: 0]
1: Recognize the control key function.
1) Select COPIER>INSTALL>KEY and enter "1".
2) Turn OFF/ON the main power switch. (The control key function is recognized.)
Initial installation of the Y/M/C color developer
Simultaneously execute a series of operation required for initial installation of the Y/M/C color
developer.
Operation method
1) Select an item to highlight it and press the OK key.
- Start the operation.
- Execute countdown.
2) After the operation completes, OK is displayed.
The settings executed by this mode are shown below.
- Electric potential control
- Primary transfer ATVC
- Development idling (adjustment of the charging volume of the developer)
- Correction of the optical volume of the patch detection sensor (adjustment of the optical volume
of the patch detection sensor)
- Transfer cleaning ACVC (determination of high pressure of the transfer cleaning upstream/
downstream brush)
- Optical ATR initial setting (initial setting of noncontact optical ATR)
- Initial setting of patch electric potential control (initial setting of patch electric potential)
- Initial setting of patch detection (initial setting of patch detection ATR)
Make a setting to invalidate the initial multiple rotations for initial installation.
This is a mode to make a setting to invalidate the initial multiple rotations for initial installation.
This mode is executed so that the image formation sequence does not operate by a patch or Dmax/
Dhalf in the initial multiple rotation sequence before initial installation is performed and does not
damage and wear the inside of the machine. When the initial setting for color toner
(FUNCTION>INSTALL>INISET-4) is normally completed, the invalidation of initial multiple
rotations is automatically released. (This prevents a failure to turn the switch back to the original
position.) When the initial setting is not completed, the invalidation is not released.
Setting range
0: Initial multiple rotations are valid.
1: Initial multiple rotations are invalid.
This is an item to control Dcon.
[Factory setting value / Value after RAM clear: 0]
Make a setting for switching the use of E-RDS.
Set if using E-RDS (Embedded-RDS) to send device information of a device counter, failure, or
consumables to a sales company's server via SOAP protocol, or not.
Setting value
0: Do not use E-RDS.
1: Use E-RDS.
[Factory setting value / Value after RAM clear: 0]
T-16-134
Contents Level
1
1
1
1
1
1
1
1
1