Canon imagePRESS C1 P Service Manual page 1102

Subheading
PASCAL
Set if using the contrast electric potential and gradation correction data obtained by automatic
gradation correction (full correction) control, or not.
Setting range
0: Use the data.
1: Do not use the data.
2: Reserve (same operation as 1)
3: Reserve (same operation as 0)
Standard value
1
The setting value becomes valid after the main power switch is turned OFF/ON.
For printer model, be sure to make the setting value 0 at installation.
CONFIG Select several system software stored in the hard disk, change the nation/area, paper size.
Procedure:
1) Select <CONFIG>.
2) Select the item to change.
3) Press the +/- key. (Each press changes the setting.)
4) Display the contents to be needed, press OK key.
5) Turn off and then back on the main power switch.
XXYYZZAA
XX: country (e.g., JP=Japan)
YY (*): language (e.g., ja=Japanese)
ZZ: (*) destination (e.g., 00=Canon)
AA: paper size series (00=AB; 01=inch; 02=A; 03=inch/AB)
*: Cannot change the setting.
TEMP-TBL Fixing assembly temperature control
Temperature settings become effective after the main power is switched OFF / ON .
Fixing assembly temperature control
Upon activation of this mode,
Temperature of the following increase by 5 deg C: stand-by temperature (both of the 2 types),
copying temperature, stand-by last rotation temperature, sheet-to-sheet temperature control for
long sheets.
Temperature of the following does not increase by 5 deg C: job last rotation temperature, power
save mode temperature, error detection temperature.
Make adjustments to the setting in the temperature control table.
The setting in the fixing assembly temperature control table is modified when certain properties
of paper used in the field cause blistering of paper or low temperature offset.
Change the setting to "0" when low temperature offset occurs.
Change the setting to "1" when blistering of paper occurs.
Setting range
0: OFF (default)
1: - 5 deg C
2: - 10 deg C
3: - 15 deg C
4: - 20 deg C
Standard value
0
W/SCNR
Set the presence/absence of the reader for the copy model.
Setting range
0: Printer model (without a scanner)
1: Model with a scanner
Standard value
0
The setting value becomes valid after the main power switch is turned OFF/ON.
RUI-DSP
Set the options for the copy function in the RUI screen.
Setting range
0: Do not display the copy screen in RUI.
1: Display the copy screen in RUI.
Standard value
0
COPIER>OPTION>BODY
Contents
Chapter 16
Level
1
1
1
1
1
16-205