Canon imagePRESS C1 P Service Manual page 1113

Chapter 16
Subheading
U-NAME
U-PASWD
CDEV-IDL
16-216
COPIER>OPTION>BODY
Set a user name that can be connected to the SSH server.
Specify a user name required to connect to the SSH server. Only one user is allowed to login.
Setting range
8 characters maximum (one-byte alphanumeric chafacter)
Standard value
gN3Fp2A
This item is for future expansion. Do not change it.
This item becomes available only when the setting value of <SSH-SW> is '1(ON)'.
Set a password of a user who can be connected to the SSH server.
Specify a password of a login user required to connect to the SSH server.
Setting range
8 characters maximum (one-byte alphanumeric chafacter)
Standard value
Vs8DuwJ
This item is for future expansion. Do not change it.
This item becomes available only when the setting value of <SSH-SW> is '1(ON)'.
Passwords are masked on the screen.
Set ON/OFF of the first power-on development idling for the color developer (YMC).
Adjust the ATR patch interval of the 1st limit.
When you increase the limit, downtime interval increases, but the density changes. When you
decrease the limit, downtime interval decreases, but the density becomes stabilized.
Trigger to start the patch detection:
(1) count by the number of copies which is reset when the patch detection is performed
(2) count by the reset video count
Timing
1. When the 1st limit (20 copies) has been exceeded, perform the patch detection by the last
rotation of that job.
2. At the point when the 2nd limit has been exceeded, discontinue the job and forcibly perform
the patch detection.
3. At the point when the reset VC has exceeded 300% (in A4 equivalent), forcibly perform the
patch detection.
1 copy = 3 images. Only YMC is counted.
Image count: 1 count for small, 2 counts for large
Setting range
0: OFF
1: ON
Standard value
1
The setting value becomes valid after the main power switch is turned OFF/ON.
Contents Level
2
2
2