Canon imagePRESS C1 P Service Manual page 1025

Chapter 16
Subheading
SCANLAMP
11. MISC-P
Subheading
P-PRINT
P-PRINT
KEY-HIST
HIST-PRT
TRS-DATA
USER-PRT
LBL-PRNT
PRE-EXP
16-128
COPIER>FUNCTION>MISC-R
Perform lighting operation of the scanning lamp.
Operation method
1) Select this item.
2) Press the OK key. The scanning lamp lights up for three seconds.
COPIER>FUNCTION>MISC-P
Print out the service mode setting value.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
It takes approximately 15 seconds before printing starts.
Print out the service mode standard value
Execute the print out of the service mode standard value.
Left/right margin adjustment value (COPIER > ADJUST > FEED-ADJ > BLK-SML2) for the
second side on small size is added as an output item.
When executing P-PRINT with a printer model, an item for second-side left/right margin
adjustment value on small size was missing. Thus, this item is added in this change.
This item applies to the upgraded device or later (DCON Ver11.03 or later, Cont Ver24.04 or
later).
Print out the control panel key input history.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
Print out the jam history and error history.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
Transfer the data received in memory to the box.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
Print out the user mode list.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
It takes approximately three seconds before printing is performed.
Print out the service label.
Operation method
1) Set the A4/LTR paper in Cassette 1.
2) Select this item.
3) Press the OK key to perform printing.
It takes approximately 15 seconds before printing is performed.
Check the lighting operation of the post-exposure lamp (LED).
Operation method
1) Press an item to highlight it.
2) Press the OK key. Each operation is performed for a few seconds and stops automatically.
3) Press the OK key to perform printing.
Reference
When a failure occurs to the photosensitive drum caused by the lighting operation of the post-
exposure lamp, rotate the drum.
T-16-131
Contents
T-16-132
Contents
Level
1
Level
1
1
1
1
1
1
1
1