When removing the copyboard glass, take care not to touch the glass
surface.
When dirt is attached, clean the glass with lint-free paper.
4) Hold the bended area [1] on the mirror stay and move the mirror 1 mount
[A] in the right direction until it stops.
5) After connecting the connector [1] of the mirror heater to the connector
[2] at the reader side, fix it with the 2 screws (RS tightening; M4X8) [3].
When attaching the mirror heater, make sure to place the front side of the
heater under the cable guide.
[2]
[3]
[1]
F-2-382
[1]
[A]
F-2-383
6) Attach the heater harness retainer [1].
- 1 screw (RS tightening; M4X8) [2]
7) Move the mirror 1 base [1] in the left direction until it stops.
8) Insert the cable clamp [1] into the hole [2] of the frame.
9) Attach the lens heater [1].
- 1 connector [2]
- 1 cable clamp [3]
- 1 screw (RS tightening; M4X8) [4]
Chapter 2
F-2-384
F-2-385
F-2-386
F-2-387
2-99