Fixing Belt Unit - Canon imagePRESS C1 P Service Manual

Chapter 9
[2]

9.7.3 Fixing Belt Unit

9.7.3.1 Preparation for Removing the Fixing Belt Unit
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
9.7.3.2 Removing the Fixing Belt Unit
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
- In the case of placing the fixing belt unit [1] on the floor, put several sheets
of paper [2] beneath it.
- In the case of holding the fixing unit, make sure not to directly touch the
surface of the fixing belt, and hold it with paper wrapped. However, you
can touch the areas of 10mm from the both edge of the fixing belt because
they are non-image areas.
- If there is any soil or scar on the fixing unit, it may cause the image fault
(such as unevenness). Clean it dry with a lint-free paper.
[1]
1) Open the external delivery cover [1].
[1]
2) Open the internal delivery cover [1].
9-38
[1]
F-9-56
[2]
F-9-57
F-9-58
[1]
3) Detach the fixing front cover [1].
- 3 screws [2]
0014-0174
0014-0175
4) Detach the fixing upper cover [1].
- 2 stepped screws [2]
- 1 screw [3]
5) Move the 2 fixing upper unit holding plates [1] in the direction of the ar-
row.
- 2 screws [2]
[2]
F-9-59
F-9-60
[1] [2]
F-9-61
[1]
[1]
[2]
F-9-62
[1]
[2]
[3]