Canon imagePRESS C1 P Service Manual page 1056

Subheading
INTROT-T
Set the interval time of auto-adjustment control (simple control)
Setting range
50 to 10000 (small image)
Standard value
400
The setting value becomes valid after the main power switch is turned OFF/ON.
AUTO-DH Set the permission/prohibition to automatically start the automatic gradation control which is
executed when the machine is left for a specified period time or the environment changes in the
ON/OFF standby condition for automatic gradation correction control.
The setting value becomes valid after the main power switch is turned OFF/ON.
Setting range
0: Prohibited
1: Permitted (default)
Standard value
1
DFDST-L1 Adjust the dust detection level for DF (between-sheet correction)
Increase the setting value to increase the dust detection level. (It becomes easier to detect dust
which causes a thin line.)
Setting range
0 to 255
Standard value
93
DFDST-L2 Adjust the dust detection level for DF (detection after job)
Increase the setting value to increase the dust detection level. (It becomes easier to detect dust
which causes a thin line.)
Setting range
0 to 255
Standard value
80
ENVP-INT Set the log acquisition interval for temperature/humidity in the machine and fixing temperature.
Set the log acquisition interval for COPIER>FUNCTION>MISC-P>ENV-PRT and
COPIER>DISPLAY>ENVRNT.
Setting range
0 to 480 (minute)
Standard value
60
Reference
Log acquisition not implemented at 0 minute.
T1-TEMP
Switch the down sequence table for thick paper 1.
Setting range
0: Default
1: Fixing is prioritized.
2: Productivity is prioritized.
Standard value
0
The setting value becomes valid after the main power switch is turned OFF/ON.
T2-TEMP Switch the down sequence table for thick paper 2.
Setting range
0: Default
1: Fixing is prioritized.
2: Productivity is prioritized.
Standard value
0
The setting value becomes valid after the main power switch is turned OFF/ON.
CD-IDL-T Adjust the time to execute idling at first power-on for the IDL-T color developer (YMC).
Set the time to execute idling at first power-on for the color developer (YMC), which is sometimes
executed by initial multiple rotations under high-humidity environment.
When you decrease the setting value, downtime of initial multiple rotations can be reduced, but
density change from the first power-on is somewhat worsened.
When you increase the setting value, density change from the first power-on is improved, but
downtime of initial multiple rotations increases.
Setting range
-3 to +6 (1 level: 5 second)
Standard value
0
The setting value becomes valid after the main power switch is turned OFF/ON.
COPIER>OPTION>BODY
Contents
Chapter 16
Level
1
1
1
1
1
1
1
1
16-159