Canon imagePRESS C1 P Service Manual page 655

Chapter 11
4) Logout once and login again to check to see that the setting is applied properly.
When password authentication has been set to Start, the password entry window will now be displayed. If password authentication has been set to Stop, when
an attempt is made to log in, the error message shown below will be displayed and login will not be possible.
Login error screen
Password authentication started
Setting for login by RLS Authentication
The procedures for changing the RLS authentication Start/ Stop settings are as follows.
1) In order to make a setting for Login by RLS Authentication, you need to Login by Password Authentication.
URL: http://<IP address of MEAP device>:8000/sms/rls/
Ex.) http://172.16.188.240:8000/sms/rls
Login screen by Password Authentication
2) Select [System Management] tab > [Utility] tab > [Application Management Function] tab.
11-10
F-11-10
Password authentication stopped
F-11-11
F-11-12