Canon imagePRESS C1 P Service Manual page 1072

Subheading
COMP-PRT When performing printing for "printing of a page number / printing of the number of copies /
printing of a date / bookbinding / printing of a tint block (hereinafter called 'combined printing')
with the copying number of 2 or more, printing is prioritized in memory allocation for image
processing for a certain memory model (option) or document size. This causes a lack of memory
for image processing of scanning, SEND transmission (excluding FAX), and PDL input
operation, and such operation cannot be performed until printing is completed.
This mode is used to perform equal memory allocation to all jobs so that operation such as
scanning, SEND transmission (excluding FAX), and PDL input can be performed before printing
is completed (so that such operation is performed little by little).
Setting range
0: Prioritize printing.
1: Perform equal memory allocation.
Standard value
0
SHT-DCSW Skip the DCON termination processing when executing shutdown.
Setting range
0: Execute shutdown after the DCON fan control is terminated.
1: Execute shutdown before the DCON fan control is terminated.
Standard value
0
ADJ-VPP Adjust the developing bias Vpp.
Function to adjust Vpp for the developing AC bias.
Setting range
-4 to 2
Standard value
0
AST-SEL Change the range of the advanced smoothing.
AST-SEL (AST level SELect)
Setting range
0 to 3
Standard value
2
REGM-SEL Change the range of the thin line density correction.
REGM-SEL (REos GaMma SELect)
Setting range
0 to 4
Standard value
2
ADJ-BLNK Adjust the length of the developing bias blank.
Function to adjust the blank length of the developing bank pulse bias
Setting range
1 to 4
Standard value
3
2TR-RVON Set ON/OFF of the weak bias of the trail edge of paper.
Set this mode to ON when scattering occurred to the trail edge of the image on the 2nd side in 1/
3 speed.
Setting range
0: OFF
1: ON
Standard value
0
USB-RCNT Auto-connection setting at disconnection of USB device (USB RECONNECT)
Setting range
0 to 1
0: Non auto-connect
1: Auto-connect
Standard value
0
COPIER>OPTION>BODY
Contents
Chapter 16
Level
2
2
2
2
2
2
2
2
16-175