Mounting The Balancing Cylinder - Canon imagePRESS C1 P Service Manual

Chapter 2
18) Fold 2 to 3 sheets of A3 paper [1] in half as shown in the figure, and then
cover the drum with them.
MEMO:
Paper is used for the purpose of preventing light-transmittance.
[1]

2.2.11 Mounting the Balancing Cylinder

imagePRESS C1 P / imagePRESS C1
- In order to even the balance inside the rotary, the developing assembly
should be mounted by the following step:
balancing cylinder [1] > balancing cylinder [2] > M developing assembly
[3] > C developing assembly [4] > BK developing assembly [5] > Y
developing assembly [6]
[4]
C
M
[3]
Y
[6]
- Attach the balancing cylinders onto the area where there is no toner supply
mouth.
1) Take out the balancing cylinders from the attached packing box.
2) Remove the developing assembly cover [1].
2-38
[1]
F-2-73
A3
F-2-74
[5]
Bk
[1]
balancing cylinder
[2]
balancing cylinder
- 1 screw [2]
[2]
3) Hold the gear at the developing assembly [1], and manually turn the de-
veloping rotary [2] counterclockwise, then with the balancing cylinder
upward, fix [A] and [B] aligned as instructed in the figure.
0012-9740
4) Open the 2 developing assembly fixing arms [1].
- 2 screws [2]
In the case of turning the developing rotary, make sure that the developing
assembly fixing arm is fixed with the screw.
[1]
F-2-75
[1]
[2]
F-2-76
[A]
[B]
F-2-77