Canon imagePRESS C1 P Service Manual page 137

[2]
8) Place a piece of A3 paper on a flat surface. Then turn the developing as-
sembly upside down and shake off the residual toner in the toner mouth
onto the paper.
Keep in mind not to touch the developing cylinder [2].
9) Fit the developing assembly [1] to the developing rotary. Check to make
sure that the pin [2] of the developing assembly is fitted in the hole [3]
located at the backside of the developing rotary.
In the case of attaching the developing assembly, make sure not to bump
into the ATR sensor shutter [1].
[2]
[1]
F-2-95
[2]
[1]
F-2-96
[1]
[2]
-After attaching the developing assembly, check to see if the hole [2] of the
ATR sensor shutter [1] is embossed.
-Push the plunger [3] of the ATR sensor shutter solenoid in the direction of
the arrow several times, and check to see if it moves back and forth.
[2]
[1]
[3]
10) Push the 2 developing assembly fixed arms [1] in the direction of [A],
set them in the direction of [B] and fix.
- 2 screws [2]
Chapter 2
[1]
[3]
F-2-97
[2]
2-43