After Replacing The Pressure Pad Cover - Canon imagePRESS C1 P Service Manual

Chapter 9
[5]
[2]
[3] [4]
[2]
2) Remove the pressure pad cover [1].
- 5 screws [2]

9.7.13.3 After Replacing the Pressure Pad Cover

imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
Before installing a belt, apply silicon oil (S-20; FY9-6011) to the marked
area of the pressure pad cover (within the radius of about 200 mm from the
center).
Apply silicon oil to the pressure pad cover, after soaking lint-free paper into
the oil to the extent that the oil does not drip from the paper.
[1]
[1] pressure pad cover
9.7.14 Fixing Main Thermistor
9.7.14.1 Preparation for Removing the Fixing Main
Thermistor
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
9.7.14.2 Removing the Fixing Main Thermistor
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Detach the fixing upper cover [1].
- 2 stepped screws [2]
- 1 screw [3]
9-50
[5]
[1]
[6]
[7]
F-9-123
[2]
[1]
F-9-124
F-9-125
2) Remove the fixing main thermistor unit [1].
- 1 connector [2]
- 1 screw [3]
0014-6123
[3]
3) Remove the fixing main thermistor [1].
- 1 screw [2]
- 1 mount [3]
9.7.15 Fixing Sub Thermistor
9.7.15.1 Preparation for Removing the Fixing Sub
Thermistor
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
9.7.15.2 Removing the Fixing Sub Thermistor
0014-0208
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the fixing upper cover [1].
- 2 stepped screws [2]
- 1 screw [3]
0014-0209
[1] [2]
F-9-126
[1]
[2]
F-9-127
[1] [2]
F-9-128
[3]
[3]
0014-0210
0014-0211