Canon imagePRESS C1 P Service Manual page 130

Chapter 2
6) Close the toner replacement cover.
7) Pull the hopper [1] in the direction of the arrow until it stops.
Points to Note when Pulling up the Hopper Unit
1, Be sure to check with eyes that the lock arm [1] on the lower left of the
hopper is hooked to the shaft [2] and the hopper unit is locked.
[2]
[1]
2, Be sure not to swing the hopper unit.
In the case the hopper unit is not fully locked, the hopper unit may drop.
8) Fold a sheet of A3 paper as shown in the figure and cover the supply
mouth [1] with the A3 paper [2].
MEMO:
The purpose of covering the supply mouth with a sheet of paper is to prevent
any contaminant from entering from the supply mouth [1].
2-36
[1]
F-2-63
A3
[2]
9) Disconnect the 6 connectors [1], and free the cable from the cable guide
[2] and the wire saddle [3].
[1]
10) Disconnect the connector [1] and the other 7 connectors [2].
[1]
11) Remove the 5 screws [1].
12) Loosen the 2 process joint shafts [1] and the ITB joint shaft [2].
[1]
F-2-64
[1]
[2] [3]
F-2-65
[2]
F-2-66
[1]
F-2-67