Canon imagePRESS C1 P Service Manual page 992

Subheading
LD-OFS-Y/M/C/K
MD-OFS-Y/M/C/K
HD-OFS-Y/M/C/K
8. HV-PRI
Subheading
PRIMARY
GRID
HVRATE-3
9. HV-TR
COPIER>ADJUST>COLOR
Adjust the color balance of low-density area. (Y/M/C/K color)
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
Adjust the color balance of middle-density area. (Y/M/C/K color)
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
Adjust the color balance of high-density area. (Y/M/C/K color)
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
COPIER>ADJUST>HV-PRI
Adjust the current of the primary charging assembly.
Adjustment range: 0 to 1200 (Unit: µA)
[Factory setting value / Value after RAM clear: 1000]
Adjust the grid bias of the primary charging assembly.
Setting range: 0 to 1000 (Unit: 1V)
[Factory setting value / Value after RAM clear: 464]
Adjust the parameter setting ratio of the primary charging bias / laser power. (Feeding speed: 1/3
speed)
Adjustment method
Adjust the parameter setting ratio of the primary charging bias / laser power at the feeding speed
of 1/3 speed.
Setting range: 0 to 100 (This can be set in the unit of 1.)
[Factory setting value / Value after RAM clear: 100]
Contents
T-16-95
Contents
Chapter 16
Level
2
2
2
Level
1
1
2
16-95