Setting Up Ipv4 Network Configuration - Quantum Scalar i6000 Installation Manual

The Network Configuration submenu only appears if you have enabled
Note
IPv6 for the physical library.

Setting up IPv4 Network Configuration

After completing steps 1 through 3 of
Configuration dialog box appears.
The following table describes the elements on the Network Configuration dialog box.
Element
In the Host Settings area:
DHCP
Library Name
IP Address
Subnet Mask
Default
Gateway
166
Setting Up the Network Configuration
Description
If Dynamic Host Configuration Protocol (DHCP) is enabled on your network,
select Enable to have DHCP automatically configure the library network
settings. Enable makes the IP Address, Subnet Mask, and Default Gateway
text boxes unavailable. Select Disable to make the IP Address, Subnet Mask,
and Default Gateway text boxes available for you to manually set the library
network settings.
The network name that you want to assign to the library.
The IP address of the library. This text box is available only if DHCP is disabled.
The subnet mask. This text box is available only if DHCP is disabled.
The IP address of the default gateway for your portion of the Ethernet network.
This text box is available only if DHCP is disabled.
on page 165, the IPv4 Network
Configuring the Library