Table of Contents
Advertisement
To carry out the transition completely: Move the lever over the full range of
To pause a partly executed transition: Stop moving the fader lever.
To resume a paused transition: Resume moving the fader lever.
Combinations of Auto and Manual Transitions
Using the [AUTO TRANS] button, the [CUT] button, and the fader lever, use
the following procedures.
Moving the fader lever during an auto transition
During an auto transition started by pressing the [AUTO TRANS] button,
operating the fader lever immediately enables the fader lever, and the [AUTO
TRANS] button goes off. Thereafter, the fader lever controls the progress of
the transition.
Executing an auto transition after partly moving the fader lever
• Press the [CUT] button to instantaneously complete the transition.
• Press the [AUTO TRANS] button to complete the rest of the transition at the
Non-Sync State
If the fader lever is in an intermediate position when a transition is completed
as an auto transition, then the lever position no longer agrees with the transition
state. This is termed a non-sync state.
In a non-sync state, two lit LEDs indicate the position from which a normal
transition can be carried out. This is either at one end position or both end
positions of the fader lever travel.
Moving the fader lever toward the position of the lit LEDs does not carry out a
transition, but when the fader lever reaches the end position the non-sync state
is released, and it is now possible to carry out the next transition.
320
Executing a Transition
its travel.
preset transition rate.
If the transition rate is set to 100 frames, and the fader lever has moved
1
through
/
of the transition, then the remaining
4
out in 100 frames.
3
/
of the transition is carried
4
Advertisement
Table of Contents
