WSM KX080-3 Service
l. Traveling motor drain amount
1. Disconnect the drain hose from the travel motor
and connect another hose (the pressure gauge
hose will do) where the drain hose was discon-
nected.
2. Float the crawlers as shown as below.
3. Run the engine one minute at max. rpm with the
lever in the forward position and measure the
amount of hydraulic oil in the pan.
4. If the measurement exceeds the specification,
determine the cause and replace the assembly.
5. Hydraulic oil tempreture must be 50 ± 5°C, 122 ±
9°F.
Reference value : See Specifications
Never place your body under the crawler.
IV-S-52
Hydraulic system