Oil Pipe; Turbocharger - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
Caution
• While the engine is running and or just after it stops, the turbocharger is hot, be careful not to touch the

turbocharger.

• NOTE
• When detaching and attaching the turbocharger assembly, be very careful not to allow dust, dirt and other
foreign matter in the oil pipes.
• When the turbocharger assembly has been replace, pour fresh engine oil through the oil filler port of the
turbocharger.
• Before starting the engine, make sure that air cleaner is in position.

Oil Pipe

1. Remove the joint bolt (5) and clamp (4) and take off the pipe 1
(2).
2. Remove the bolts (1) and release the clamp (6).
3. Disconnect the oil pipe 2 (7) and pipe 4 (3).
(When reassembling)
• Pour fresh engine oil through the oil filler port of the
turbocharger.
• Replace the gasket with new one.
• Be careful not to allow dust, dirt and other foreign matters in the
oil pipes.
NOTE
• Tape or plug all openings to prevent foreign matters from
damaging the oil cavities in the turbocharger.
(1) Bolt
(2) Oil Pipe 1
(3) Oil Pipe 4
(4) Clamp
Turbocharger
1. Remove the screw (1) and bolt (3).
2. Take off the turbocharger assembly (2).
(When reassembling)
• Replace the gasket with new one.
(1) Screw
(2) Turbocharger Assembly
III-S-117
(5) Joint Bolt
(6) Clamp
(7) Oil Pipe 2
W1025983
(3) Bolt
W1078106
Engine