Cover Assembly - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
3)Mountthe input gear[6] on the shaft [15].
Note : Apply grease to the steel ball [36] so it
doesn't fall out when mounting the
cover [8].
4)Fit the steel ball [36] in the steel ball
mounting hole of the input gear [6].

(17) Cover assembly

1) Introduce 1.3 liters of lubricating oil.
Note : Apply grease to the O-ring [29].
2) Mount the O-ring [29] in the O-ring groove
of the cover [8].
3) Place the cover [8] on the hub [1], matching
the marks to restore it is its original position.
Note : After positioning the cover above, force
it into the hub [1] by lightly tapping with
a plastic hammeron and around its rim.
Avoid strong tapping or the O-ring [29]
will get out of its groove to result in
imperfect sealing.
4) Look the cover [8] in place by installing the
ring [18].
IV-S-187
Hydraulic system