Gm Motor Disassembly Procedure - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
2-3.Disassembly procedure
(1 ) Washing the travel motor
1) Fasten the eyebolts in the screw holes for
mounting the spindle [2].
Note : Fasten the 2 eye bolts in the screw
holes for mounting the spindle [2] so
they are positioned symmetrically.
2) Hook the wire in the eye bolts, hoist the
travel motor with a crane and carry to the
washing tank.
3) Wash each part of the travel motor with a
car wash brush.
Note : Earth and sand get in the clearance
between the hub [1] and spindle [2]
(floating seal mounting section). Be
sure to wash this part with special
care.
(2) Travel motor installation
1) Set the travel motor on a workbench
Note : While matching the hub bolts of the hub
[1] and screw holes of the workbench,
carefully place the travel motor in the
mounting holes of the workbench.
2) Mount the travel motor on the workbench
and tighten hexagon nuts to the hub bolts.
Caution
Tighten the hexagon nuts securely. Failure to
do so could result in injury cased by the travel
motor falling when it is inverted.
IV-S-149
Hydraulic system