Kubota KX080-3 Workshop Manual page 563

WSM KX080-3 Service
3) Remove the parallel pins [242] from the rear
flange [201].
4) Remove the ball bearing [150] from the rear
flange [201].
(9) Disassembly of plugs inside rear flange
1) Remove the plugs [224] (2 plugs) from rear
flange [201].
2) Remove the O-ring [236] from the plug
[224].
Note : Do not reuse the O-ring [236] which has
been removed.
3) Remove the spool [223] from the rear
flange [201].
Note : The spool [223] will slip out and fall if
you tilt the rear flange [201] so that
one of the plug ports is facing
downward. Grip the ends and remove.
4) Remove the plugs [282] (2 plugs) from rear
flange [201].
5) Remove the O-ring [238] from the plug
[282].
Note : Do not reuse the O-ring [238] which
has been removed.
IV-S-155
Hydraulic system