Gm Motor: Assembling Instructions - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
9. Assembling instructions
1) Operational precautions in general
(1)As done for disassembling, prepare a
working bench and tools.
(2)Pay attention as done for disassembling.
(3)Before assembling, remove bits of metal or
foreign material from all the parts, and also
check that there is no burrs or dents on the
parts. If you find burrs or dents, remove
them with an oilstone.
(4)As a rule, replace all 0-rings and NHU
packing with new one.
(5 Install the 0-rings and NHU packing, taking
care not to damage them. (Apply a little
amount of grease for smooth installation.)
(6)To prevent the parts from dropping, use
grease.
(7)Tighten the bolts with the torque shown in
the assembly cross-section drawing.
(8)After the assembling is completed, close
all the ports with plugs to prevent dust from
entering.
2) AssembIing procedures
1.Fix the Casing (101) on a vice using cushion
sheets. Set the steel ball (192) in the Casing
(101).
(RCVD8CC only)
2.Set the Seat (191) in the Casing (101).
(RCVD8CC only)
IV-S-122
Hydraulic system