WSM KX080-3 Service
Caution
When mounting the snap ring [25], if the tip of
the pliers slips out of the hole of the snap ring,
the snap ring [25] couldjump out.
Note : Mount with the acute angle of the snap
ring end face facing up.
3) Mount the snap rings for the shaft [25] (3
snap rings) in the snap ring groove of the
crankshaft [9].
(8) Mounting on the spindle
Caution
You could get burned while performing this
task, so use leather gloves to perform
insertion.
Be careful not to get burned.
Note : Insert until the large diameter side
collarofthe inner ring of the ball
bearings [149] adhere to the collar
surface of the shaft [102].
1) Place ball bearings [149] in a heating tank,
heat at 100 10°C for 10 minutes, and
pressfiton the shaft [102].
IV-S-177
Hydraulic system