Gm Motor Disassembly; General Suggestions When Working - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
2. DISASSEMBLY
2-1. Preparation
Perform the following
disassembling.
2-1.1. Workbench preparations
Provide a travel motorworkbench.
Provide a sturdy workbench with which the
internal parts of the travel motor can be
disassembled or assembled, is wide enough
to place parts so they do not move or fall off
the bench while working.
Spread a rubberor vinyl sheet on the
workbench.
2-1.2. Preparation of tools and materials
Provide the tools and materials listed in 1-1.
2-2. General suggestionswhen working
Caution
Internal parts are coated with hydraulic fluid
during disassembly and are slippery If a parts
slips out of your hand and falls, it could result
in bodily injury or could damage the parts. Be
very careful when handling.
Caution
Combustibles such as white kerosene are
used forwashing parts. These combustibles
are easily ignited, and could result in fire of
injury. Be very careful when handling.
(1) Before disassembling, perform inspections
and clearly determine the nature of any
abnormalities which might be occurring,
and work according to the disassembly
procedure.
(2) Each parts is manufactured to extreme
precision. Handle with care and be sure
not to hit the parts together or drop them.
(3) When working, do not attempt to forcefully
beat or wrench tightly fitting parts. Doing
so could produce burrs or damage the
parts so they can't be mounted or may
reduce their performance. You should
exercise patience when working.
(4) If you leave parts disassembled or partially
disassembled, rust could develop on the
preparations before
IV-S-148
parts due to moisture or dirt. If you have to
interrupt work before completion, be
careful to take measures to protect
against rust or dust.
(5) Place a counter mark on mating faces of
parts when disassembling.
(6) Arrange removed parts neatly when
disassembling so as not to damage or
lose the parts while working.
(7) As a rule, once any type of seal is
disassembled it should be replaced with a
new one even if it shows no signs of
damage. You should have a new ready
when disassembling.
(8) The photographs and drawings contained
in the manual are of representative
models. Disassembly
however not affected even if the product
you are using differs in part.
Hydraulic system
procedure is