Kubota KX080-3 Workshop Manual page 586

WSM KX080-3 Service
2) Invert the travel motor
3) Apply lithium grease to the lip section of the
oil seal [132], and press fit the oil seal [132]
in the oil seal hole of the spindle [2] with the
retainer (2) and hammer.
4) Mount the parallel pins [177] (2 pins) in the
pin holes of the spindle [2].
5) Apply lithium grease to the hemispherical
surface of the pivots [176] (2 pivots), and
set in the parallel pins [177] of the spindle
[2].
6) Attach to the spring [185], piston assembly
(piston [161], shoe [162]).
7)Dip hydraulic fluid in the sliding parts of the
piston assembly (piston [161], shoe [162])
and mount in the piston hole of the spindle
[2].
8) Tilt the travel motor90 degrees.
9) Apply lithium grease to the splines of the
motor shaft [102].
Note : Take care not to scratch or cut the lip
portion of the oil seal [132] in place
with splined foremost end of the shaft
[102].
IV-S-178
Hydraulic system