Assembly Of Plugs In The Rear Flange - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
2) Mount the O-rings [135], [141] in the O-ring
grooves of the piston [112].
At this time, apply a thin coat of grease to
the O-rings [135], [141].
3) Mountthe piston [112] in the spindle [2].
Note : If it is difficult to place the piston [112] in
the spindle [2] due to resistance of the
O-rings [135], [141], insert by tapping
the end face of the piston [112] with a
plastic hammer. When mounting the
piston [112], be careful not to damage
the O-rings.

(12)Assembly of plugs in the rear flange

1) Insert the valve [227] into the rear flange
[201].
2) Mount the O-rings [238] (2 rings) on the
plugs [282] (2 plugs).
Note : Apply grease to the O-rings [282].
3) Insert the unified plugs [282] (2 plugs) in the
rear flange [201] and temporarily tighten
with a hexagonal wrench.
IV-S-181
Hydraulic system