Reamer Bolt Fastening; Fitting The Snap Ring - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

(5) Reamer bolt fastening

Note : If grease adheres to the screw section
corresponding to the reamer bolt [19]
of the spindle [2], degrease with
degreaser and wash.
1)Apply bonding agent to screw section of the
spindle [2].
Note : Tighten the 3 reamer bolts [19] equally,
a little at a time.
If you tighten 1 or 2 before the other,
the hold flange [3] will tilt, and you will
not be able to correctly insert the ball
bearing [21] in the hold flange [3].
2)Tighten the reamer bolts [19] (3 bolts) to the
specified torque.
Specified torque : 794 49.0 N-m
3)Invert the travel motor.
4)Remove the fixtures (2 fixtures).
5)Invert the travel motor.

(6) Fitting the snap ring

1)Check if the spindle kit and RV gear
assembly parts haven't been replace with
new ones.
Note : If there are no renewal parts, proceed
to the next step (2).
If there is even 1 renewal part,
proceed to the next step (6) after
carrying out "(19) Shaft direction
clearance adjustment of the tapered
roller bearing".
IV-S-175
Hydraulic system
(81.0 5.0kgf-m)
586 36 ft-lbs